You probably know the use of math expressions in Neobook's SetVar:

- Code: Select all
`SetVar "[z]" "10"`

SetVar "[z]" "[z]+1"

However, math expressions can used in e.g. the control commands If, IfEx, While, WhileEx and Loop also, resulting in shorter code. I did not find a post on this topic. So I made some examples for you and hope you'll find these helpful.

Best regards,

Reinier

- Code: Select all
`...................................................................`

.Examples of math expressions in Neobook's SetVar and

.control commands If, IfEx, While, WhileEx and Loop

...................................................................

SetVar "[x]" "3"

SetVar "[y]" "2"

SetVar "[z]" "1"

...................................................................

...................................................................

While "[z]" "<" "3"

AlertBox "Result 1" "Value of variable z: [z]"

SetVar "[z]" "[z]+1"

EndWhile

......................................................................

If "[x]+[y]" ">" "[z]"

AlertBox "Result 2" "[x]+[y] > [z] is TRUE"

Else

AlertBox "Result 2" "[x]+[y] > [z] is FALSE"

EndIf

......................................................................

IfEx "[x]+[y] > [z] AND [x]-[y] = [z]"

AlertBox "Result 3" "[x]+[y] > [z] AND [x]-[y] = [z] is TRUE"

Else

AlertBox "Result 3" "[x]+[y] > [z] AND [x]-[y] = [z] is FALSE"

EndIf

......................................................................

WhileEx "[x]^2 > 0 AND [x]*[y] > 0"

AlertBox "Result 4" "Value of variable x and y: [x] and [y]"

SetVar "[x]" "[x]-1"

SetVar "[y]" "[y]-1"

EndWhile

......................................................................

.initialize [y] again because of the last example

SetVar "[y]" "2"

......................................................................

If "Sqrt([y])" "<" "[z]"

AlertBox "Result 5" "Sqrt([y]) < [z] is TRUE"

Else

AlertBox "Result 5" "Sqrt([y]) < [z] is FALSE"

EndIf

......................................................................

.solving an equation for a > 0

Loop "1" "Sqr([y]+[z])" "[a]"

If "[a]*[a]-3*[a]-3" "=" "[a]-3"

AlertBox "Result 6" "a*a-3a-3 = a-3 is TRUE for value [a]"

ExitLoop

EndIf

EndLoop

......................................................................

......................................................................

. Try it yourself and use Neobook's math operators and functions:

. + - * / ^

. Abs

. Sin Cos Atan,

. Sqr Sqrt Round Trunc