Page 1 of 1

Copy and Paste

PostPosted: Sat Oct 29, 2016 2:23 pm
by BRobinsonS
For quite I while I thought it would be good when copying and pasting objects that the pasted object be offset slightly from the original object.

Is this a possible ?
For new comers copying and pasting over the original position would make them think that the pasting did not happen.

Just a suggestion.

Re: Copy and Paste

PostPosted: Sat Oct 29, 2016 3:40 pm
by CN_Iceman
I don't like that idea. Maybe If you allow select it as an option, it would be much better.

Re: Copy and Paste

PostPosted: Sat Nov 05, 2016 5:40 pm
by Neosoft Support
You can also copy and object by holding down the Ctrl key and dragging with the mouse. This allows you to deposit the duplicate object wherever you like.