Page 1 of 1

On Error Clause...

PostPosted: Sun Oct 03, 2010 3:44 pm
by David de Argentina
Hi Dave,

I'm doing a very complex program. When I receive an error message, program resumes execution and most of actions/values were changed.

As I can't pause the program when an error message are displayed, I canĀ“t check the variable values and/or what code is wrong.

I think a variable (or function) like as "OnErrorDebugBreakPoint (on/off)" will be very, very useful...

Could be this possible?

Thanks in advance,
David de Argentina

PostPosted: Sun Oct 03, 2010 11:34 pm
by smartmedia
Hi..

I have face the same problem over and over again and your suggestion is very good.

PostPosted: Mon Oct 04, 2010 10:33 am
by Neosoft Support
I'll look into it.