NeoSoft Support Forum

Hi all, I am using the "PrintImageFileWH" action command but am finding that it's not printing more than one images in a row, it prints one then stops printing. After resetting the printer by on and off it prints the next image. I'm having to basically reset the printer after a print. Is there a command to reset the printer after a print? Maybe this will help resolve my issue. Any helpful suggestions always appreciated. The command I am using is: "PrintImageFileWH "[TempFolder]Printout.jpg" "6.1466666666666665" "2.066666666666667". It is an image file 1844x620 pixels and converted to inches as needed. I notice that when the printer comes back it prints a tiny line of the previous image and eventually prints the next image file. Best regards Anthony

Hi Anthony am sure the issue is not from Neobook but rather from your printer.
I tried this command worked perfectly.



Did you try it on a different printer?

Hi HackinHoodLogicsTm, that works great for me too except the images don't print at size required (6.15 x 2.07 inches). A workround found being stop the print spool, delete anything left in folder PRINTERS and then restart print spool.