Page 1 of 1

SendMail command

PostPosted: Sat Jul 27, 2013 3:55 pm
by Gaev
Has anyone had success in using the SendMail command to send an email through their gmail account ?

With help from deployment on another (server) platform, I tried using ...

[MailServer] =
[MailPort] = 465
[MailUserID] =
[MailPassword] = xxxx

... without success ... it hangs forever (even [HTTPTimeout] is set).

If anyone has had success, perhaps you can share values you used for the afore mentioned variables.

Re: SendMail command

PostPosted: Sat Jul 27, 2013 6:36 pm
by David de Argentina
Hi Gaev,

Gmail server uses SSL & TLS security protocols in order to connect to.
SendMail command connect with a non-secured mail server.
You can connect Gmail using this service:


or using this plugin: ... =3&t=17640

My devaluated cent,
David de Argentina

Re: SendMail command

PostPosted: Sun Jul 28, 2013 5:34 am
by Gaev
David de Argentina:

Thank you for the quick response ... and references to possible solutions.

I sent you a PM ... which also includes a suggested work around for the 9 parameter limitation of the Call command.

Re: SendMail command

PostPosted: Mon Jul 29, 2013 10:15 am
by Gaev
David de Argentina:

Yesterday, I followed up with an email to you ... was sent via this forum ... I hope your profile points to the correct address ... and hope you got it.